WaveMaster + AnyWave
BOLAB WaveMaster software and the BOLAB AnyWave control unit allow the control of power supplies as well as 4 quadrant amplifiers via the analog interfaces.
The powerful and easy to use BOLAB WaveMaster software is unique in the world. Without any knowledge in software development, designing ordinary and complex waveforms is very easy. A graphic waveform editor allows the generation
of individual curves in no time. Also, with a tabular input all types of waveforms can be produced instantly.
BOLAB AnyWave Control Unit
The BOLAB AnyWave control unit controls all kind of power supplies as well as 4 quadrant amplifiers via the analogue interfaces. It has two analogue outputs to provide two waveforms synchronously to different power supplies / 4 quadrant amplifiers. Sampling rates of 2,8 MS/s, 16 bit and 250 kS/s, 16 bit units are available.
BOLAB’s AnyWave control unit provides a bandwidth of up to 300 kHz very easy.
It’s internal memory is handled by a double buffer mode which provides endless data streams without any interruption! Waveforms of almost infinite lengths can be simulated. This provides the most advantage in comparison to any function generator solutions which are limited in their memory and speed due to their limited arbitrary function!
BOLAB AnyWave Control Unit
- 2 Channel Arbitrary Waveform Generation
- Live Data Acquisition
- Graphic / Tabulator Waveform Design
- Importing Real Waveforms (e.g. from Oscilloscopes)
- Complete Standard Waveform Libraries
- Protocol Report with Recorded Data
- DLLs for Python, LabView, CANoe, etc.
#Open an existing file
fileName = ,,F:\\Waveform1MV.and"
openfileRet = wavemaster.OpenFile(fileName)
#Arbitrary System Function
sys=WaveMaster.GetArbitrarySystem()
#Configure the device settings
#Define source andamplifier
source = ,,NI DAQ USB-6259"
amplifier = ,,SIB 105-75E-TS"
#Set System
setSysRet = sys.Set (1, source, amplifier,0,0,0)
time.sleep(5)
#Load wave form into instruments memory
sys.Load()
#Enable output
sys.Execute()
#Start running of waveform with burst=5
sys.Start(5)
#Wait until waveform ends after 5 runnings
run = sys.IsRun()
while run == 1:
time.sleep(0.5)
run = sys.IsRun()
#Set output to standby
sys.Standby()
WaveMaster control via DLL´s
- Easy to use graphic waveform editor and tabular input
- Reference waveform and data acquisition with live graphics
- Including standard libraries for:
- LV124, VW 80000
- LV148, VDA 320
- LV123, VW 80300
- GMW
- JLR
- etc.
Large database library for standards
- Command library to build-up or for integration into automated test systems such as:
- LabView
- Vector CANoe (CAPL)
- Vector via C# real time!
- Python
- C#
- C++
- ANSI C
- MATHLAB
- etc.
- Simulation of imported oscilloscope signal
Protocol Report
- Generate your protocol report automatically
- Including reference waveform and measured values for voltage and current
- One click report
Import Oscilloscope / ASCII Data
The simplicity of how fast oscilloscope data signals can be imported is exceptional. Reading ASCII and TDMS data files is also possible the same way.
Online measurement
———- Reference voltage as well as voltage measurement
———- Current measurement
BOLAB AnyWave is a control unit that allows to generate analogue signals for the power supplies and 4 quadrant amplifiers as well as for recording data for both voltage and current measurements to produce these synchronous and live in parallel to the reference waveform. Data generation and data acquisition was never that easy.
